Precautions for daily maintenance of structural adhesive equipment dry powder mixer

The structural adhesive equipment of the dry powder mixer belongs to high-frequency application equipment and is widely used in dry powder mortar drying machine companies. Some companies even produce and manufacture continuously 24 hours a day. Therefore, the equipment must be maintained regularly to ensure its normal operation during production and manufacturing. With the gradual arrival of winter, the temperature gradually decreases, and the route of the dry powder mixer may also be damaged by freezing and hardening, especially in colder areas in the north. So, the regular maintenance of the structural adhesive equipment of the dry powder mixer is a key daily task, and every shift of workers must strictly follow it after production and manufacturing. When maintaining the equipment, it is necessary to pay attention to the following aspects:

1. The structural adhesive equipment of the dry powder mixer should be placed in a dry and non corrosive natural environment to ensure its normal use period. The dry powder mixer is generally made of carbon steel and painted with a layer of anti-corrosion paint. If left in a natural environment with corrosive substances for a long time, it is still very easy to rust.

2. After the application of the structural adhesive equipment of the dry powder mixer, try to clean and wipe the inside of the drum and mixing blades with cold water as much as possible. If not in use for a long time, rust inhibitor can be applied to the inside and surface of the blades. If the raw materials on the mixer blades are not cleaned up neatly, they will clump and become difficult to clean after being left unused for a long time. In the case of further mixing, it will endanger the efficiency and refinement of the mixing process.

3. Always pay attention to whether the standard parts are loose after application and immediately tighten them. Large and medium-sized dry powder mixers are all equipped with operating platforms, and regular checks should be carried out on the fasteners.

4. It is prohibited to insert hard blocks such as nails and fine wires into concrete and gravel during feeding to prevent damage to mechanical equipment. Before feeding, try to select raw materials as much as possible to ensure that there are no other residues.

5. After using the structure adhesive equipment reducer of the dry powder mortar dryer mixer for a period of time, the height of the lubricating oil level should be checked, and the oil level should be immediately filled to the observation hole where the oil level can be seen. The oil is 30 # mechanical lubricating oil. Lubricating oil is an important part of mechanical equipment. If the lubricating oil is not immediately filled, it will cause damage to the transmission system position. Therefore, it is necessary to regularly maintain the lubricating oil.